Prev: low frequency amplification
Next: analog switch
From: John Doe on 7 Aug 2010 18:35
I took the scooter motor cover off and a 3/8 inch diameter soft
rubbery round O-ring fell out. Any clue as to what that was for? It
was broken, pretty weak. My guess is that it was being used for the
front bearing spacer. There is not much else in there, except big
magnets and the rotor.

So I screwed the motor cover back on and attached the 36 V cordless
drill controller to the motor contacts. Appears to work fine,
probably should watch out for excessive heat?

The motor is rated for up to 48V.

Thanks.
First  |  Prev  | 
Pages: 1 2
Prev: low frequency amplification
Next: analog switch