Prev: Outputting time steps with ode15s
Next: Outputting time steps with ode15s
From: Joseph Corcoran on 10 Feb 2010 13:03
Deal All,

I'm having a few problems in my project which requires reading in measurements from a digital vernier caliper using Matlab.

My current plan is to trust this circuitry that is required http://www.compendiumarcana.com/caliper/ but the programme is no good as needs to read on to Matlab for the rest of the project. So I need to write my own!...

If anyone would be able to help it would be massively appreciated. Is it possible? Ideally I would like a continuous feed of measurements, but at worst readings when instructed. Is there anything I should look out for?

Thanks,
Joe

joseph.corcoran07(a)imperial.ac.uk
 | 
Pages: 1
Prev: Outputting time steps with ode15s
Next: Outputting time steps with ode15s