Prev: Nikon film scanners orphaned for 64 bit
Next: Acer Scanwit 2740 With Vuescan
From: GigaNews on 3 Apr 2010 21:23
I have a CanoScan 9900F on my compueter. The drivers are installed and I can
see the drivers under Control Panel/System/Device Manager/Imaging Devices.
Under properties it says the device is working properly. But when I run any
of my graphic applications, like Photo Studio 5, Photo Shop 7, Prest Page
Manager or Paint, they don't recognize the scanner as if it wasn't connected
to the computer. I did go to the Canon site and downloaded and installed the
Vista drivers. Any ideas?
Thank you

Tony

From: CSM1 on 4 Apr 2010 00:44
"GigaNews" <adfmart(a)hotmail.com> wrote in
news:LbudnX-4St6PdyrWnZ2dnUVZ_tidnZ2d(a)giganews.com:

> I have a CanoScan 9900F on my compueter. The drivers are installed and
> I can see the drivers under Control Panel/System/Device
> Manager/Imaging Devices. Under properties it says the device is
> working properly. But when I run any of my graphic applications, like
> Photo Studio 5, Photo Shop 7, Prest Page Manager or Paint, they don't
> recognize the scanner as if it wasn't connected to the computer. I did
> go to the Canon site and downloaded and installed the Vista drivers.
> Any ideas? Thank you
>
> Tony
>

Did you use the TWAIN driver?

Start here for your driver.
http://www.usa.canon.com/consumer/controller?act=DownloadIndexAct

--
CSM1
http://www.carlmcmillan.com
 | 
Pages: 1
Prev: Nikon film scanners orphaned for 64 bit
Next: Acer Scanwit 2740 With Vuescan