Prev: Very small business router
Next: Question on mmc_queuecell error
From: ajn on 4 Mar 2010 18:36
I have a 1760 router setup with CME 4.3 and has two dsp's installed in the
router. I have all my voip and analog phone setup and working and able to
make and receive incoming and outgoing calls to the pstn via my fxo port on
my home phone line.

I am trying to setup my dspfarm on the router, in which this will connect up
to my 2621xm router that is the voice gateway router for my CUCM/Unity
segment of my lab.

When I configure my dspfarm on my 1760 router which has two dsp's I it show
I have no transcoder session available. My router config is posted here

http://ajn1963.pastebin.com/2bqLbgzh

It also show that my dspfarm is down. I am not sure what I am missing.

Any assistance would be greatly appreciated.

Thanks,


AJ



a-vgw-cucme-c1760#sh dspfarm sessions 1

Total number of active connections 0 with session_id 1

a-vgw-cucme-c1760#sh dspfarm all
DSPFARM Configuration Information:
Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN
Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 1 (Avail: 1)
Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 60
Connection check interval 60 Codec G729 VAD: ENABLED

Total number of active session(s) 0, and connection(s) 0

a-vgw-cucme-c1760#config t
Enter configuration commands, one per line. End with CNTL/Z.
a-vgw-cucme-c1760(config)#ds
a-vgw-cucme-c1760(config)#dspfarm ?
codec Configure codec related parameters for DSPFARM service
confbridge Specify the conferencing related parameters values
connection Specify the dspfarm connection related parameters values
profile Specify the DSPFARM profile information
rtp Specify the RTP related parameters values
transcoder Specify the transcoding related parameters values
<cr>

a-vgw-cucme-c1760(config)#dspfarm tr
a-vgw-cucme-c1760(config)#dspfarm transcoder ?
maximum Specify the transcoding parameters maximum value

a-vgw-cucme-c1760(config)#dspfarm transcoder max
a-vgw-cucme-c1760(config)#dspfarm transcoder maximum se
a-vgw-cucme-c1760(config)#dspfarm transcoder maximum sessions ?
<0-0> Specify the maximum transcoding sessions value

a-vgw-cucme-c1760(config)#dspfarm transcoder maximum sessions 5
^
% Invalid input detected at '^' marker.

a-vgw-cucme-c1760(config)#
a-vgw-cucme-c1760(config)#



 | 
Pages: 1
Prev: Very small business router
Next: Question on mmc_queuecell error