Prev: flash drives showing none installed
Next: VBS Script To Get PC's Information And Send To Excel
From: ME on 29 Jul 2010 15:20
Two questions: 1. Under disk management, I marked one of my drives 'active'.
What does that mean and how do I mark it as not active, as in revert it back
to whatever state it was in before - or do I care? 2. This one has been a
major annoyance. No matter which USB slot I plug it into or which drive I
plug in first, one of my external hard drives always sets to 'J' when I need
it permanently 'I'. So annoying! As is, I keep having to change the drive
letters and paths each time - 'I' to 'J' and 'J' to 'I' What gives?!
Apparently my computer has marked the drive permanently 'J'. How can I make
it so it's always 'I'? And the monkey presses the 'Post' button... Thanks!


--
ME
From: Pegasus [MVP] on 29 Jul 2010 16:37


"ME" <ME(a)discussions.microsoft.com> wrote in message
news:89E4CB8E-6E4A-4405-861B-78D5991031C2(a)microsoft.com...
> Two questions: 1. Under disk management, I marked one of my drives
> 'active'.
> What does that mean and how do I mark it as not active, as in revert it
> back
> to whatever state it was in before - or do I care? 2. This one has been a
> major annoyance. No matter which USB slot I plug it into or which drive I
> plug in first, one of my external hard drives always sets to 'J' when I
> need
> it permanently 'I'. So annoying! As is, I keep having to change the
> drive
> letters and paths each time - 'I' to 'J' and 'J' to 'I' What gives?!
> Apparently my computer has marked the drive permanently 'J'. How can I
> make
> it so it's always 'I'? And the monkey presses the 'Post' button...
> Thanks!
>
>
> --
> ME

It's not a "drive" that is marked active but a "partition". Windows will
boot off the active primary partition on the primary master disk. If there
is no active partition then it will not boot. On other disks, the "active"
attribute has no effect. You could remove this attribute with the Console
utility "diskpart.exe" but unless you are experienced with such commands I
recommend you leave it alone.

I suspect you keep getting drive J: instead of drive I: because drive I:
refers to a remembered share connection. If so then you can avoid the
problem by removing the remembered connection as per the steps below. A far
simpler method would be to just accept the letter J: as it is. If the shoe
fits, wear it!

Removing a remembered connection:
1. Open a Command Prompt.
2. Type the following commands:
net use /persistent:no
net use * /del /yes

 | 
Pages: 1
Prev: flash drives showing none installed
Next: VBS Script To Get PC's Information And Send To Excel