From: BRASTO on
When switched on: sound and picture appears. E/W amplitude is too
small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536
(6.8R 1W) runs very hot. The TVset switches to SBY (protection mode)
after aprox 6 seconds.

When reapplying power the same event happens.

Running the set on a ballast lamp with HOT disconnected shows no
problems, B+ however is believed to be a little low (130 VDC rather
than 148 VDC)

Could the HV transformer be defective ? other suspects ?

TIA
Bram

From: Inty XP on
In data Sun, 25 Jun 2006 16:33:09 +0200, BRASTO <bram.stolk(a)gmail.com> ha
scritto:

> When switched on: sound and picture appears. E/W amplitude is too
> small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536
> (6.8R 1W) runs very hot. The TVset switches to SBY (protection mode)
> after aprox 6 seconds.
>
> When reapplying power the same event happens.
>
> Running the set on a ballast lamp with HOT disconnected shows no
> problems, B+ however is believed to be a little low (130 VDC rather
> than 148 VDC)
>
> Could the HV transformer be defective ? other suspects ?
>

Oh, maybe if you say the chassis number...

> TIA
> Bram
>



--
Inty.Evolution
intiglietta(a)email.it -> per email normali e con immagini Jpeg
From: Inty XP on
In data Sun, 25 Jun 2006 16:33:09 +0200, BRASTO <bram.stolk(a)gmail.com> ha
scritto:

> When switched on: sound and picture appears. E/W amplitude is too
> small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536
> (6.8R 1W) runs very hot. The TVset switches to SBY (protection mode)
> after aprox 6 seconds.
>
> When reapplying power the same event happens.
>
> Running the set on a ballast lamp with HOT disconnected shows no
> problems, B+ however is believed to be a little low (130 VDC rather
> than 148 VDC)
>
> Could the HV transformer be defective ? other suspects ?
>

Hello, Beko 22.1 chassis :) as you wrote in Sts Board :)
> TIA
> Bram
>



--
Inty.Evolution
intiglietta(a)email.it -> per email normali e con immagini Jpeg
 | 
Pages: 1
Prev: HP 54110D
Next: 2N60B substitute?