Prev: ARM-based desktop computer ? (Hybrid computers ?: Low + High performance ;))
Next: could clash
From: Myauk on 22 Jul 2010 00:20
Dear All,

I am going to design a power line modem device using HomePLug Command
and Control for a final year engineering project.

I googled a lot to get the device specific informaiton on this but
can't get relevant info until now.

I only see a few white papers describing only general features of
HomePlug Command and Control.

It only says HomePlug Command and Control uses

If anybody has experience in this area, please share me.

Regards
From: Werner on 31 Jul 2010 13:50
On 22/07/10 12:20, Myauk wrote:
> Dear All,
>
> I am going to design a power line modem device using HomePLug Command
> and Control for a final year engineering project.
>
> I googled a lot to get the device specific informaiton on this but
> can't get relevant info until now.
>
> I only see a few white papers describing only general features of
> HomePlug Command and Control.
>
> It only says HomePlug Command and Control uses
>
> If anybody has experience in this area, please share me.
>
> Regards

The specifications are very hard to come by and expensive.
There is an open source project "FAI FA" (Thai for electricity).
https://dev.open-plc.org/
Your browser may need to get a security exception to access the site.

Maybe you can glean something from there.

Regards
Werner Dahn

 | 
Pages: 1
Prev: ARM-based desktop computer ? (Hybrid computers ?: Low + High performance ;))
Next: could clash