Prev: i2c help need with pull up resistor problem
Next: NI-DAQmx 8.7.2
From: Sithu on 7 Aug 2008 01:10
Hi,
      Is there any hardware modules other than those developed by NI, can be programmed by LabVIEW?
    Message Edited by Sithu on 08-06-2008 11:51 PM
From: parthabe on 7 Aug 2008 01:40
<a href="http://forums.ni.com/ni/board/message?board.id=170&amp;thread.id=347355" target="_blank">duplicate</a> post.
From: parthabe on 7 Aug 2008 01:40
Do you want to design an application that uses non-NI modules using LabVIEW&nbsp;or do you want to write device drivers for non-NI modules using LabVIEW?
From: Sithu on 7 Aug 2008 01:40
Can you give me the details of both?
From: Dennis Knutson on 7 Aug 2008 10:10
Your question is incredibly vague. Could you narrow down the type of hardware you are interested in? At the very least, the physical connection to the PC? PCI, Ethernet, GPIB, serial, USB? Don't say 'All'.
 |  Next  |  Last
Pages: 1 2
Prev: i2c help need with pull up resistor problem
Next: NI-DAQmx 8.7.2