Prev: RoHS/PbF for customers
Next: Kyocera receiver not remembering stations
From: GregS on 21 Apr 2010 12:14
I am looking for a power connector pinout on this supply.
Not the remote connector. Most of the connections are apparent, but
I'm trying to verify a fan output, as I'm told.

Greg
From: Samuel M. Goldwasser on 21 Apr 2010 19:45
zekfrivo(a)zekfrivolous.com (GregS) writes:

> I am looking for a power connector pinout on this supply.
> Not the remote connector. Most of the connections are apparent, but
> I'm trying to verify a fan output, as I'm told.

Should be close to the other supplies that run similar lasers:

http://www.repairfaq.org/sam/laserasc.htm#ascom15

--
sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
 | 
Pages: 1
Prev: RoHS/PbF for customers
Next: Kyocera receiver not remembering stations