Prev: New Independent Mastercam Forum Starts Up.
Next: Delcam For SolidWorks
From: Joe788 on 9 Nov 2009 10:56
On Nov 8, 8:16 pm, Joe788 <larryro...(a)yahoo.com> wrote:
> Where has all the development for Delcam Featurecam really been
> going?
>
> http://jonbanquer.wordpress.com/new-delcam-for-solidworks-video/
>
> No need to put up with worthless gossip, off topic political nonsense,
> etc. in these newsgroups from the usual suspects when you can read the
> Jon Banquer blog and get the real story!
>
> The Jon Banquer blog is the leading CAM-centric blog in the internet
> and gets hundreds of hits per day. If you're not reading the Jon
> Banquer blog you can be sure of one thing... your competition is! ;>)

'Tis a shame that all we get now is Copy/Paste Banquer. Uninformed
Incorrect Broad Statment Banquer was a lot more fun. When do your meds
run out again Jon, so we can get our little self humiliating buddy
back?

First  |  Prev  | 
Pages: 1 2
Prev: New Independent Mastercam Forum Starts Up.
Next: Delcam For SolidWorks