OVM7690-R20A how to wire it
in [Embedded]
|
Prev: atmega48 adc at faster than best clock speeds
Next: how to enable prink message on EP9307(linux 2.6.8.1)
From: USB wcam on 4 Feb 2010 17:03 Hi, I have a OVM7690-R20A CameraCube image sensor from OmniVision, the device is very small I need to wire it with a protoboard. Does anyone know how this device can be wired ?? Thanks in advance --------------------------------------- Posted through http://www.EmbeddedRelated.com
From: linnix on 4 Feb 2010 23:04 On Feb 4, 2:03 pm, "USB wcam" <wjimenezc(a)n_o_s_p_a_m.hotmail.com> wrote: > Hi, I have a OVM7690-R20A CameraCube image sensor from OmniVision, the > device is very small I need to wire it with a protoboard. > Does anyone know how this device can be wired ?? > Looks like 0.2mm pitch. It can be done with fine-pitch PCB, but not for cheap.
From: USB wcam on 5 Feb 2010 11:09 >On Feb 4, 2:03=A0pm, "USB wcam" <wjimenezc(a)n_o_s_p_a_m.hotmail.com> >wrote: >> Hi, I have a OVM7690-R20A CameraCube image sensor from OmniVision, the >> device is very small I need to wire it with a protoboard. >> Does anyone know how this device can be wired ?? >> > >Looks like 0.2mm pitch. It can be done with fine-pitch PCB, but not >for cheap. > ***************************************************************************** Well, the device contact dimension are 2.518mm (square), so the contact leads are very small. Do you have a part number and where can I get this PCB ? Do you have a price in mind ? Any information that can guide me ? Thanks --------------------------------------- Posted through http://www.EmbeddedRelated.com
From: linnix on 5 Feb 2010 13:00
On Feb 5, 8:09 am, "USB wcam" <wjimenezc(a)n_o_s_p_a_m.hotmail.com> wrote: > >On Feb 4, 2:03=A0pm, "USB wcam" <wjimenezc(a)n_o_s_p_a_m.hotmail.com> > >wrote: > >> Hi, I have a OVM7690-R20A CameraCube image sensor from OmniVision, the > >> device is very small I need to wire it with a protoboard. > >> Does anyone know how this device can be wired ?? > > >Looks like 0.2mm pitch. It can be done with fine-pitch PCB, but not > >for cheap. > > ***************************************************************************** > > Well, the device contact dimension are 2.518mm (square), so the contact > leads are very small. Sorry, should be 0.4mm or 0.5mm pitch. 0.2mm or 0.3mm lines. I believe it's 2.5mm (side) / 5 (pads per side) = 0.5mm, but I have to see the exact pad layout to be sure. > Do you have a part number and where can I get this PCB ? Most PCB fab can do this. You just have to give them the layout and connections you want. > Do you have a price in mind ? Depends on the pad layout, probably $50 to $100. > Any information that can guide me ? > > Thanks > > --------------------------------------- > Posted throughhttp://www.EmbeddedRelated.com |