From: Tilman Schmidt on
From: Tilman Schmidt <tilman(a)imap.cc>
Subject: [PATCH 1/4] gigaset: small documentation improvement

Clarify the non-support by isdnlog, and propose a better standard
debug mask.

Impact: Documentation
Signed-off-by: Tilman Schmidt <tilman(a)imap.cc>
---
Documentation/isdn/README.gigaset | 10 +++++-----
1 files changed, 5 insertions(+), 5 deletions(-)

diff --git a/Documentation/isdn/README.gigaset b/Documentation/isdn/README.gigaset
index 794941f..e472df8 100644
--- a/Documentation/isdn/README.gigaset
+++ b/Documentation/isdn/README.gigaset
@@ -292,10 +292,10 @@ GigaSet 307x Device Driver
to /etc/modprobe.d/gigaset, /etc/modprobe.conf.local or a similar file.

Problem:
- Your isdn script aborts with a message about isdnlog.
+ The isdnlog program emits error messages or just doesn't work.
Solution:
- Try deactivating (or commenting out) isdnlog. This driver does not
- support it.
+ Isdnlog supports only the HiSax driver. Do not attempt to use it with
+ other drivers such as Gigaset.

Problem:
You have two or more DECT data adapters (M101/M105) and only the
@@ -321,8 +321,8 @@ GigaSet 307x Device Driver
writing an appropriate value to /sys/module/gigaset/parameters/debug, e.g.
echo 0 > /sys/module/gigaset/parameters/debug
switches off debugging output completely,
- echo 0x10a020 > /sys/module/gigaset/parameters/debug
- enables the standard set of debugging output messages. These values are
+ echo 0x302020 > /sys/module/gigaset/parameters/debug
+ enables a reasonable set of debugging output messages. These values are
bit patterns where every bit controls a certain type of debugging output.
See the constants DEBUG_* in the source file gigaset.h for details.

--
1.6.5.3.298.g39add

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo(a)vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/