Prev: Differentiation of a dirac function
Next: Boxplot Y-Axis Change
From: Farrukh on 5 Aug 2010 11:14
Dear,
I tried to build "ert_shrlib.tlc" of a simulink model which uses Rectangular QAM Modulator block, i configured it as
Input Type : Bit
Constellation ordering: Gray
Normalization method: Average Power
Average power, referenced to 1 ohm (watts) = 1
Phase offset (rad): 0
the input is col. matrix of 416x1 from General Block Inter-leaver.

It works fine for simulation but whenever i tried to build "ert_shrlib.tlc" with RTW
It gives error following error

Error reported by S-function 'scomapskmod4' in 'ieee80211n/ModulatorBank/ModulatorSS1/Modulator 1/Rectangular QAM Modulator Baseband':
In sample-based bit input mode, the input must be a vector whose width equals the number of bits per symbol. "
"
Please help, i spent almost one day to figure out this but could not ...........

Thanks
 | 
Pages: 1
Prev: Differentiation of a dirac function
Next: Boxplot Y-Axis Change