Prev: Fuzzy Logic
Next: DAQ digital input, change detection event
From: Eric Brewer on 2 Mar 2010 13:22
Hello all,
I am using the Simulink report generator, and I would like to document the properties contained in all the inports in a section "Inputs" and the outports in a section "Outputs". The 'signal loop' component allows me to select input or output signals, but the 'block loop' component does not. I tried puting a block loop inside a signal loop, but then it selects all the blocks connected to the signal. Is there a way to only generate tables for the inports/outports?

I also tried to use an 'if' statement but I am not sure what variables that I need to compare. Is there a way to see all the available variables in a section?

Sorry for so many questions....any help is appreciated.

-Eric
 | 
Pages: 1
Prev: Fuzzy Logic
Next: DAQ digital input, change detection event