Prev: DAQ digital input, change detection event
Next: Classification problem
From: Arkadiy Turevskiy on 2 Mar 2010 14:26
To create a table of all inports and outports for each subsystem:
- use System Loop component, in "Loop on Systems" select Custom -use system list and in the dialog box below put
%<gcs>

Then use Block Summary Table as a child component. In Block Summary Table component, close to the bottom in Loop Options check the box "Search for Simulink name/property value pairs".

Add property/value pair. In property Name column type BlockType, in Property Value column type Inport.

To repeat for the outports add another Block Summary table component, set all the options the same as above, but change Inport to Outport in property Value column.
Arkadiy


"Eric Brewer" <piano_man354(a)yahoo.com> wrote in message <hmjl0d$hgq$1(a)fred.mathworks.com>...
> Hello all,
> I am using the Simulink report generator, and I would like to document the properties contained in all the inports in a section "Inputs" and the outports in a section "Outputs". The 'signal loop' component allows me to select input or output signals, but the 'block loop' component does not. I tried puting a block loop inside a signal loop, but then it selects all the blocks connected to the signal. Is there a way to only generate tables for the inports/outports?
>
> I also tried to use an 'if' statement but I am not sure what variables that I need to compare. Is there a way to see all the available variables in a section?
>
> Sorry for so many questions....any help is appreciated.
>
> -Eric
 | 
Pages: 1
Prev: DAQ digital input, change detection event
Next: Classification problem