Prev: Image Sequence labelling problem
Next: How to plot in MATLAB this simple figure
From: Danny on 16 Jun 2010 18:17
When using the sim command in 2010a to run a model, I get the warning:
Result of power is undefined in ModelName/BlockPath/BlockName

What causes this? The exact same code did not do this yesterday.
From: Walter Roberson on 16 Jun 2010 20:20
Danny wrote:
> When using the sim command in 2010a to run a model, I get the warning:
> Result of power is undefined in ModelName/BlockPath/BlockName
>
> What causes this? The exact same code did not do this yesterday.

Is it possible that you now have a block that is generating 0 to the
power 0 ? That is undefined.
 | 
Pages: 1
Prev: Image Sequence labelling problem
Next: How to plot in MATLAB this simple figure