Prev: More Of SolidCAM's New iMachining Toolpaths
Next: The Jon Banquer Blog Is Getting A Face Lift
From: vinot on 7 Sep 2009 07:07
Hi all!

I'm trying to animate how a nut rolls over its screw (SW 2007), but no
way!

any tip?

thanks

toni
From: Cliff on 7 Sep 2009 11:15
On Mon, 7 Sep 2009 04:07:29 -0700 (PDT), vinot <freaktoni(a)gmail.com> wrote:

>Hi all!
>
>I'm trying to animate how a nut rolls over its screw (SW 2007), but no
>way!
>
>any tip?
>
>thanks
>
>toni

Plus there would be two ways, right?
--
Clif
From: Reaper2561 on 8 Sep 2009 13:16
On Sep 7, 7:07 am, vinot <freakt...(a)gmail.com> wrote:
> Hi all!
>
> I'm trying to animate how a nut rolls over its screw (SW 2007), but no
> way!
>
> any tip?
>
> thanks
>
> toni

toni,

I have an example of this, but I don't remember where I got it from.
If you give me the last three letters of your email adress, I will
email it to you. I got freakt. File size is 330 kb.

Reaper.
From: johnsuth on 9 Sep 2009 00:12
In <30afd140-bdbd-48b8-893a-af407a5edd31(a)y9g2000yqn.googlegroups.com>, vinot <freaktoni(a)gmail.com> writes:
>Hi all!
>
>I'm trying to animate how a nut rolls over its screw (SW 2007), but no
>way!
>
>any tip?
>
>thanks
>
>toni

What have you tried so far?


From: vinot on 10 Sep 2009 05:13
hi again,

yes, will be two ways (up and down)

I'm trying to cut the screw section along one rod using helix path...
till now no good result :(

anyway, I have the example of Reaper (thank again), so I hope today
will have done.

toni
 |  Next  |  Last
Pages: 1 2
Prev: More Of SolidCAM's New iMachining Toolpaths
Next: The Jon Banquer Blog Is Getting A Face Lift