Prev: How to make the output always be betweeb 0 and 1
Next: facial features extraction
From: Viswanath Nittala on 24 Jun 2010 01:33
Hi,
I need help urgently..
I have a problem at hand. I need too simulate a power system network in simulink, with all that syn generator, load and slack bus.
I have learnt from help that the model needs to be set at an initial state as that of steady state. But am unable to figure out hw to get those values. I have seen a simulink demo in wich his model was runnin perfect bcos of exact initial setting.
Once I get to kno d initial states, I will hav to perform a load flow on the network.

But hw do i get dose initial states, I am just given the generator configuration, slack bus config., trx line config..
 | 
Pages: 1
Prev: How to make the output always be betweeb 0 and 1
Next: facial features extraction