Prev: Plotting periodical measurement data with jitter to matlab
Next: gaplotpareto
From: Sheraz Shahid on 10 Nov 2009 10:38
Hello Everyone,

I have a problem, basically I am running an edge detection demo in the Video\Imaging Blockset, I am using a camera which the Matlab environment supports. The problem is that when I connect and select this camera within the demo and start the simulation the following error message is diplayed,

Cannot propagate 3-D signal from output port 1 of block 'demoimaqsl_edgedetection/From Video Device' to input port 1 of block 'demoimaqsl_edgedetection/Edge Detection'. The latter block does not accept signals with greater than 2 dimensions (either entirely or in its current configuration). - did not match any documents.

I am new to this area so could someone kindly advise what it is I doing wrong?

Thankyou

Regards

S
 | 
Pages: 1
Prev: Plotting periodical measurement data with jitter to matlab
Next: gaplotpareto