Prev: How do I reformat existing line lengths in Word 2007?
Next: Page numbers in margins
From: cayce on 5 Mar 2010 10:46
I've been doing a lot of content removal and rearrangement. When I view
headers/footers in a Word 2007 .docm file, they number from beginning to end
like this: Section 1, 2, 3, 4, 7, and 8.

The fallout from this is the page numbering for section 7 will not continue
from previous section. Is there a way to make the section numbers sequential
again so my page numbers will correct themselves? Also, is this a cautionary
tale about not cutting whole sections and moving them (I have a mix of
landscape and portrait pages).

I've never experienced non-sequential section numbering before.

From: Suzanne S. Barnhill on 5 Mar 2010 11:26
The sections are inarguably sequential (there aren't any missing); it's just
that not every section has an accessible header and footer because some of
them are "continuous" and are in the middle of a page (for example, around
multi-column sections). In order to address page numbering in those
sections, you must be in the respective section; at least Word 2007 makes it
easier to access the Page Number Format dialog from anywhere in a document.

You can use the browse buttons at the bottom of the vertical scroll bar to
Browse by Section. This should allow you to access each section in turn.
Watch the section and page numbers on the status bar, and when you come to a
section where page numbering is restarted, go to Insert | Header and Footer
| Page Number | Format Page Numbers... and select "Continue from previous
section." Repeat as needed until the numbers are sequential throughout the
document.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"cayce" <cayce(a)discussions.microsoft.com> wrote in message
news:B017EB1F-ED42-4146-93C2-B46459F656DE(a)microsoft.com...
> I've been doing a lot of content removal and rearrangement. When I view
> headers/footers in a Word 2007 .docm file, they number from beginning to
> end
> like this: Section 1, 2, 3, 4, 7, and 8.
>
> The fallout from this is the page numbering for section 7 will not
> continue
> from previous section. Is there a way to make the section numbers
> sequential
> again so my page numbers will correct themselves? Also, is this a
> cautionary
> tale about not cutting whole sections and moving them (I have a mix of
> landscape and portrait pages).
>
> I've never experienced non-sequential section numbering before.
>
>

 | 
Pages: 1
Prev: How do I reformat existing line lengths in Word 2007?
Next: Page numbers in margins