Prev: MCC Compiler Problem
Next: Problem with pcolor and griddata
From: Eric on 11 Feb 2010 10:22
I am using the "Setup" Simulink block from Softing ("CAN-AC2-PCI B1 CAN 1/ CAN 2 Standard / Extended") to configure the SJA1000 CAN controllers of my Peak CAN MSMCA104+ CAN Board. I set the board, bus and slot to valid values. When I am running the model on xPC target the following error appears:

"CAN-AC2-PCI driver: CAN_AC2-PCI not present in the target system"

What is going wrong here?
Isn't SJA1000 a self supported driver for each CAN board independent of the board manufacturer?
 | 
Pages: 1
Prev: MCC Compiler Problem
Next: Problem with pcolor and griddata