Prev: Trouble with Altium Openbus document based UART example using TSK3000A
Next: Decoupling for Altera Cyclone II 2C8
From: sambad20 on 15 Jun 2010 07:48
Hi all dear
I have a DLC9G programmer for programming all FPGAs It was working good but
from some days before I don't know why but after connecting programmer to
board the LED is getting green but when I select Initialize chain in impact
software I have an error that it says you don't have adequate voltage and
some thing like this.please say to me what I should do.

thanks alot



---------------------------------------
Posted through http://www.FPGARelated.com
 | 
Pages: 1
Prev: Trouble with Altium Openbus document based UART example using TSK3000A
Next: Decoupling for Altera Cyclone II 2C8