Prev: Strange problem about Virtex-5 during working
Next: Need to run old 8051 firmware
From: max on 20 Apr 2010 07:44
Hello,

what i need for programming,reading etc a XILINX XC2018 44PLCC ?What
is the good tool?
I need a toll for repairing old boards that have the XC2018 on board,


Thanks
From: Farhad Abdolian on 20 Apr 2010 08:24
You need a VERY OLD xilinx tools from the 90s. Xilinx M1 probably works. None of the new ISE versions support 2000 series, some older ones (4.2 and older) supporter 4000 series, but nothing as old as xc2018.

---
frmsrcurl: http://compgroups.net/comp.arch.fpga/Developin-tool-for-Xilinx-XC2018
From: HT-Lab on 20 Apr 2010 09:07
In addition to what others have suggested you might also be able to use a PLCC
adaptor and use that to piggyback a modern FPGA. Companies like Enterpoint and
OHO Electronik might be able to make one of these modules for you.

http://www.enterpoint.co.uk/component_replacements/craignell.html
http://www.oho-elektronik.de/index.php?c=1&s=product1

Hans
www.ht-lab.com

"max" <ciulandro(a)yahoo.com> wrote in message
news:1d4a4320-7e52-4598-af30-99de67b254c8(a)a9g2000vbb.googlegroups.com...
> Hello,
>
> what i need for programming,reading etc a XILINX XC2018 44PLCC ?What
> is the good tool?
> I need a toll for repairing old boards that have the XC2018 on board,
>
>
> Thanks


From: d_s_klein on 20 Apr 2010 13:12
On Apr 20, 4:44 am, max <ciulan...(a)yahoo.com> wrote:
> Hello,
>
> what i need for programming,reading etc a XILINX  XC2018 44PLCC  ?What
> is the good tool?
> I need a toll for repairing old boards that have the XC2018 on board,
>
> Thanks

If you are -repairing- boards, you do not need a programmer or
reader. What you need is a supply of parts (and good luck with that).

If you are -modifying- boards, your best bet (ref HT-LAB) is to
replace the 2018 with something that you can actually use. It could
probably be replaced with a modern CPLD.

RK
 | 
Pages: 1
Prev: Strange problem about Virtex-5 during working
Next: Need to run old 8051 firmware