Prev: "TM_DATA_PARITY_ERROR"
Next: enable cli command logging howto
From: barret bonden on 17 Dec 2009 13:02
What would be the minimal setup necessary for a successful ping out the
inside interface ?

I assume all I would have to do is setup an IP address on the inside
interface in the same subnet as the rest of my LAN.
I souldn't need NAT or the Global commands working, and I should not need
statics or an access list , right ?
So something like

interface ethernet 1 100full
nameif ethernet1 inside security100
ip address inside 192.168.0.238 255.255.255.0

is really all I would need, no ?


We picked up an old 515 E to use as a back up. I want to get it on the local
net so I can upload the config from the working 515.
As it stands I cant get to first base. No pings, no fun




From: Igor Mamuzi� aka Pseto on 19 Dec 2009 04:23
"barret bonden" <support(a)networks-cc.com> wrote in message
news:4b2a7225$0$4982$607ed4bc(a)cv.net...
> What would be the minimal setup necessary for a successful ping out the
> inside interface ?
>
> So something like
>
> interface ethernet 1 100full
> nameif ethernet1 inside security100
> ip address inside 192.168.0.238 255.255.255.0
>
> is really all I would need, no ?
>
Pinging inside interface should b working...All you have to do iz to setup
interface nameif security level ip address and no shut...This is for
versions 7.0 and earlier...For older versions I'm not sure since I don't
have hands on expirience with older PIX os...


From: Shawn Westerhoff on 19 Dec 2009 15:51
On Dec 19, 1:23 am, "Igor Mamuziæ aka Pseto"
<igor.mamuzicMAKNI_...(a)zg.t-com.hr> wrote:
> "barret bonden" <supp...(a)networks-cc.com> wrote in message
>
> news:4b2a7225$0$4982$607ed4bc(a)cv.net...> What would be the minimal setup necessary for a successful ping out the
> > inside interface ?
>
> > So something like
>
> > interface ethernet 1 100full
> > nameif ethernet1 inside security100
> > ip address inside 192.168.0.238 255.255.255.0
>
> > is really all I would need, no ?
>
> Pinging inside interface should b working...All you have to do iz to setup
> interface nameif security level ip address and no shut...This is for
> versions 7.0 and earlier...For older versions I'm not sure since I don't
> have hands on expirience with older PIX os...

Send us output from show interface, and make sure you have a straight
patch cable to your inside switch. If you are using 5.x PIXOS then
"conduit permit icmp any any" as I recall but it has been a while.
The 515 should have 6.xx though. Keep in mind the OS needs to match
for the config to come across, you might simply copy the "sh run" and
paste in the config a line or 4 at a time to catch any errors. sh
version will show your PIXOS and licensing details, that would be
helpful.
 | 
Pages: 1
Prev: "TM_DATA_PARITY_ERROR"
Next: enable cli command logging howto