Prev: Importing all files from a folder
Next: Repeating Sequence Interpolating Breakdown
From: P.Y. on 8 Apr 2010 03:02
Hi,

I am learning wind turbine system using the Wind Farm (DFIG detailed model)

I found that when I remove the blocks inside the wind turbine block and try to connect directly to the grid, the simulation results are different.

Can anyone help in explaining why is this happened please?

Thank you
From: Rune Allnor on 8 Apr 2010 03:39
On 8 apr, 09:02, "P.Y. " <py...(a)hotmail.com> wrote:
> Hi,
>
> I am learning wind turbine system using the Wind Farm (DFIG detailed model)
>
> I found that when I remove the blocks inside the wind turbine block and try to connect directly to the grid, the simulation results are different.
>
> Can anyone help in explaining why is this happened please?

Does it really surprise you that changes to the system under
simulation cause changes in the results of the simulation?

Rune
From: P.Y. on 8 Apr 2010 03:58
Hi,

What I mean is I simulate the original system and observed the results. After the simulation session complete, I bring the blocks out from the wind turbine block and connect to the grid directly, then start another session of simulation again. All the connection remain the same just that without putting those blocks as subsystem of the wind turbine and the results are different compare to the original system. Hope this clarify the problem.

Regards
 | 
Pages: 1
Prev: Importing all files from a folder
Next: Repeating Sequence Interpolating Breakdown