Prev: wind turbine demo
Next: xpc target for pc104: specific setup?
From: Nate Kando on 8 Apr 2010 03:50
This is a minor problem, but I am curious if I am causing it because I would like to fix it so I do not need to explain the glitch to each person I send my model to.

When the model is closed, the next time that it is reopened,
the Repeating Sequence Interpolating block no longer functions.
Instead, it reads out the following error upon building:

Error in '.../Repeating Sequence Interpolated': Parameter 'slDataTypeAndScale(('double'),('2^-10'))' cannot be evaluated. MATLAB error message:

Changing the parameters and then changing them back, moving the block, copying and pasting a new block, etcetera all remain ineffective, however; replacing the block with a new one from the Library Browser completely solves the problem until the next close and reopening of the model.

I am using vectors of length 50 for output and time parameters, if this is any part of the cause.
 | 
Pages: 1
Prev: wind turbine demo
Next: xpc target for pc104: specific setup?