Prev: Repeating Sequence Interpolating Breakdown
Next: Grayscale Image
From: Marco on 8 Apr 2010 03:53
Hi.

I'm trying to use xpc target 3.4 for a PC104 board. The board has a R6040 ethernet chip. By trial and errors, I found out that selecting the SMC91C9X driver (ISA-bus, TC/IP connection), the boot floppy is correctly installed on the PC104 (no error message displayed on the target). However, when I try to connect the host to the target via UTP cable, the connection fails (error 7: ConnectError), even if the led light near the UTP plugs (at host and target) is on, showing that there is "some activity".

I used the xpc target for desktop targets PC in the past, and I had no problems.

Is there some specific issue when using PC104? Where am I wrong?
From: Gordon Weast on 8 Apr 2010 09:24
Marco,

I strongly suggest you contact tech support about this. That will
get the correct person to help you. I'm not the Ethernet expert
in the group.

We'll need a lot more information about your setup to figure out
what's wrong.

Gordon Weast
xPC Target Development
The MathWorks

Marco wrote:
> Hi.
>
> I'm trying to use xpc target 3.4 for a PC104 board. The board has a
> R6040 ethernet chip. By trial and errors, I found out that selecting the
> SMC91C9X driver (ISA-bus, TC/IP connection), the boot floppy is
> correctly installed on the PC104 (no error message displayed on the
> target). However, when I try to connect the host to the target via UTP
> cable, the connection fails (error 7: ConnectError), even if the led
> light near the UTP plugs (at host and target) is on, showing that there
> is "some activity".
>
> I used the xpc target for desktop targets PC in the past, and I had no
> problems.
>
> Is there some specific issue when using PC104? Where am I wrong?
 | 
Pages: 1
Prev: Repeating Sequence Interpolating Breakdown
Next: Grayscale Image