Actel FPGA corePWM IP
in [FPGA]
|
Prev: Call for Paper The International Journal of Computer Science (IJCS)
Next: Multple architectures in ISE top level module?
From: RaulGonz on 11 Feb 2010 03:19 Hi, I wish to know if anyone of you out there is using an Actel FPGA board and knows how to generate PWM signal using the corePWM IP? If you do, please let me know as i am having a hard time trying to follow the application note provided by actel on the corePWM. Thank you!
From: Antti on 11 Feb 2010 04:52 On Feb 11, 10:19 am, RaulGonz <raull...(a)hotmail.com> wrote: > Hi, > > I wish to know if anyone of you out there is using an Actel FPGA board > and knows how to generate PWM signal using the corePWM IP? If you do, > please let me know as i am having a hard time trying to follow the > application note provided by actel on the corePWM. Thank you! VERY EASY use the mouse put coreABC and corePWM into the design, wire up with the mouse in smartdesign and it just works, it does Antti
From: RaulGonz on 11 Feb 2010 21:55 Hi Antti, Do you happen to know if coreABC works in Libero IDE v8.6? I tried to put in coreABC but the system prompted this error "CoreABC_Generator.exe failed with code 32768". Please advise. Thank you.
From: Antti on 12 Feb 2010 07:50
On Feb 12, 4:55 am, RaulGonz <raull...(a)hotmail.com> wrote: > Hi Antti, > > Do you happen to know if coreABC works in Libero IDE v8.6? I tried to > put in coreABC but the system prompted this error > "CoreABC_Generator.exe failed with code 32768". Please advise. Thank > you. works with 8.5 not sure about anything else contact actel support, it should work with 8.6 also Antti |