Prev: What XTAL OSC is this?
Next: Moto 68HC11 dev kit
From: Michael A. Terrell on 22 May 2010 16:26

John Larkin wrote:
>
> On Sat, 22 May 2010 10:42:49 -0700, Archimedes' Lever
> <OneBigLever(a)InfiniteSeries.Org> wrote:
>
> >On Mon, 3 May 2010 11:54:01 -0500, "George Jefferson"
> ><phreon111(a)gmail.com> wrote:
> >
> >>
> >>
> >>"Archimedes' Lever" <OneBigLever(a)InfiniteSeries.Org> wrote in message
> >>news:3ohtt59bi5n1d6lblmpgq31m5ghb9ihdpi(a)4ax.com...
> >>> On Mon, 3 May 2010 13:02:31 +0100, "Nial Stewart"
> >>> <nial*REMOVE_THIS*@nialstewartdevelopments.co.uk> wrote:
> >>>
> >>>>> I think 950F should've been more than enough.. It didn't even touch it.
> >>>>> It simply just puddled
> >>>>> and rolled off.
> >>>>
> >>>>What the base material?
> >>>>
> >>>>If the panel is acting as a massive thermal sink then you could be heating
> >>>>the solder to 950 while the panel's getting nowhere near that.
> >>>>
> >>>>You could try pre-heating a corner with a blow torch (as long as this
> >>>>isn't
> >>>>going to destroy the panel).
> >>>>
> >>>>
> >>>>Nial.
> >>>>
> >>> When are the total retards and totally retarded suggestions in this
> >>> group ever going to end!?
> >>
> >>When you stop posting?
> >>
> >>
> > Youre IQ dropped 20 points the moment your sent that retarded post.
>
> Youre?
>
> >
> > Wait! It was already that low!
>
> Think about that statement. You never were a math whiz.


No, he prefers to 'whiz' on electric fences.


--
Anyone wanting to run for any political office in the US should have to
have a DD214, and a honorable discharge.
First  |  Prev  | 
Pages: 1 2 3 4
Prev: What XTAL OSC is this?
Next: Moto 68HC11 dev kit